AMT 1/24 2006 Camaro Concept Car

Camaro Concept Amt. In my opinion, always worked for General Motors, the car was released in March 2009, as the Camaro in 2010.

This is a new toy, I saw the box on my desk for a while ', then opened, the pieces of verification, and found that the AMT is done entirely new post and the big, the parts have been replaced by a different bag worn bag and causing the tire decals or problems clear, they all bagged separately as well. Nice!

I found a bag with a frame and shell. I found that the shell with a decal and laser in the frame ID has increased production trains needed sanding frame. The first thing I do is wash the pieces in the old Dawn dishwashing detergent with a toothbrush to remove mold release, and print, and then left soaking in the dishwasher until the day after he admitted RACK plate dry air.

On the way home the next day I was very lucky, as the owner of a local body shop actually buy one of his men, and displayed in front of the store. New metallic orange paint, white Calla stripes, similar to the '68 version, usually with Chevy orange paint in silence. I had better luck in the research and found that the local dealer, that my father and I have two vehicles purchased from, also has a red coat and a diamond-hard metal, I'm better off with them, e - mail me some pictures of cars on online web is used as a reference, give me to show them the finished model, and if printed copy is available for them, to appear in the dealers, who initially did not believe that other modelers for modelers to review that information about the equipment, and purchases.

In doing my research, and related to the physical machine, I found a major deficiency with other papers guests, but the correction was published in one of the local lines to harvest for the lights to the tail. The site is located on the panel at the bottom of the trunk line, which met with fiberglass bumper, then the top of the previous model's tail light.

Priming / sanding / polish Paint plastic Questions

After drying, the shell that I have on my Tamiya paints, and sprayed the shell with Dupont Vari-Prime Primer Part 2, which I use for almost 15 years ... It dries flat and can be Retouched, or use a little touch-up HVLP gun spraeála, if the compressor can accommodate.

After allowing the primary to sit a few days, I took the soap and water began with 4000 and 6000 and then refined the model and remove the mold lines and 9 is that 9 points should be injected on top of the peg to hold the glass in place.